Share your experience!
This is a complete puzzel to me
On doing a speed test using Analti I am getting on the network (RJ45) not wifi around 97mb a pc using the same cable (cat6) is getting 320mb, so I take the cable out of the pc and pug it into the tv and get around 97mb WHY
I have not reset the tv yet, the wifi on the tv is turned off, its right up to date on the software side.
Any ideas I can look at guys
Solved! Go to Solution.
The LAN of TV Is 10/100, her limit is 100 Mbits.
Thank you for your reply, but there is a problem.
before I upgraded from 150mb to 300, when I did the speed test I would get 147mb somewhere round about that, I then was upgraded to 300mb and it show under 100mb, thats what I dont understand if the tv is limited to 10/100 how did I get just under 150 showing on the tv.
I know that I am now getting 300mb for sure. I just dont get it.
Thank you and I will have to check this further
Peter
I have checked and your right it is limited but there maybe a way around it
https://www.youtube.com/watch?v=PIef8iRZhLE
going through the USB port by getting an adaptor RJ45 to USB
I will give that a go
Naznačite sviđanje na Facebooku
Pretplatite se na YouTubeu