Community

eric_hutchings

The handset (RMT D259) for my SVR HDT1000 HDD recorder is not allowing me to access the System Menu, Title List and Guide functions. Everything else is ok. Have reset the hdd with no effect,

Any suggestions, do I need a new hand controller?

Anonymous

Hi there

A couple of things to try

Ensure that you have not accidently reset the remote control IR codes. See page 44 of the manual : Here
Failing another remote control (and assuming you have tried fresh batteries) - You could "carefully" prise the remote control apart, and clean the contacts of where the rubber buttons meets the PCB board.
Failing that, you may wish to replace the remote control. See the following page : Here

Cheers

View solution in original post

Anonymous

Hi there

A couple of things to try

Ensure that you have not accidently reset the remote control IR codes. See page 44 of the manual : Here
Failing another remote control (and assuming you have tried fresh batteries) - You could "carefully" prise the remote control apart, and clean the contacts of where the rubber buttons meets the PCB board.
Failing that, you may wish to replace the remote control. See the following page : Here

Cheers

eric_hutchings

Bingo, amazed how much fluff there was inside.

eric_hutchings

Worked for a while, but have now ordered a replacement,

Thanks

Anonymous

Its a shame that it didnt work for longer. Was worth a try at least.

Join now - be part of our community!

HDD recorder

HDD recorder